1000-1200TPH Granite Crushing Plant In Southeast Asia

Granite Crushing Process

The granite is evenly fed by ZSW490*130 feeder into PEW1100 European hydraulic jaw crusher for coarse crushing and then gets into CSB240 cone crusher for secondary crushing. Furthermore, the material after being crushed would get into 2Y2460 for screening where the unqualified material would be sent back for another crushing while the material less than 150mm gets into HPT300 for third stage crushing. When the material is less than 40mm, it would enter into VSI5X-1145 impact crusher for shaping. After this step, the customer can get finished products whose sizes are 0-5mm 5-10mm, 10-20mm respectively.

Project Advantages

1. Advanced European hydraulic jaw crusher, V-typed structure crushing cavity, strong crushing force and large capacity; Adjustable discharging size with wedge hydraulic system. It is convenient and can save commissioning time. Besides, it is very convenient for maintenance because of centralization lubrication.

2. At the third-stage crushing, multi-cylinder hydraulic cone crusher is used. Combining faster rotation speed with stroke improves greatly rated power and capacity of HPT crusher and increases crushing ratio and production efficiency. At the same time, through the design of the special crushing cavity and the rotating speed, proportion of fine cubic material gets improved. Thin oil lubrication is automatic and can save labor costs. Besides, it is also very convenient to repair equipment while production and operation costs decrease.

3. The production line adopts three-stage crushing, which achieves the maximum optimization of crushing ratio at all levels of crushing. The middle screening after secondary crushing directly selects a part of finished products, not only reducing crushing pressure of third-stage cone crushing, but also optimizing capacity of the whole production line to a large extent.